| Quantity: | |
|---|---|
1. What is MaxPro-VST?
MaxPro is a series products of plug-and-play portable interactive-display device from Tallpic. It is used to turn any projection/LCD display into an interactive pen-touch board for low cost.
MaxPro-VST is a model with largest FOV thus the receiver(pen scanner) can be located very closed to the screen. This brings some advantages
2. MaxPro features
◆ Plug-and-play, no need to install any software or driver.
◆ Laser beam for pointing indication.
◆ 4-point calibration.
◆ Supports up to 10-point multi-touch(Windows/Android).
◆ Supports up to 100 inch area.
◆ Zero system resource occupation, performs perfectly on low-cost or heavy loaded systems.
◆ Models available for Windows/Mac and Windows/Android.
◆ Wireless connection(optional).
3. Application
Class rooms
Conference rooms
4. Packaging
MaxPro-VST scanner x 1
Infrared pen x 1
1.5m USB signal/Power supply cable x 1
Pen charging cable x 1
Product manual x 1
Wireless dongle x1
5. Product views
1.Camera
2.Red laser
3.Signal indicator
4.Sensor cabin
5.USB socket
2.4G Wireless dongle:
5. Product installation
You can mount the receiver device at any place only if the view of the camera can cover the screen. However, for best performance please choose the distance as recommended below.
6. Coordinate calibration
When you use Maxpro for the first time or the device is moved after last calibration, you need to do calibration.
Quickly click 4 times on ‘Caps Lock’key of the keyboard, after a beep from the scanner, a laser beam will be seen. At this point, you need to adjust the pointing of the scanner.
In Windows and Mac OS system, the cursor guided 4-point calibration will be activated. The cursor will first appear near the upper left corner and vibrate slightly. Press the infrared pen tip at the cursor and keep still until you hear a beep(from inside of the device). This indicates the calibration of this point is finished. The cursor will move to the next point. With the same operation, complete 4 points calibration. Please note that a beep must be heard before you move to the next point. After calibrating successfully, you will hear two short beeps. The system is ready now.
In Android system, the only difference is that you need to start a drawing application so that a marking point will be shown at each calibration point.
Hints：
1. Please keep the pen stable until a beep is heard.
2. Please complete the process in time. The system will automatically terminate the process if no action is detected for a long time.
3. If you hear a long beep after calibration, it indicates that the data is incorrect. If it happens, you will need to do calibration again correctly.
7. Gesture command
This is a useful function of Maxpro.
